DTF TRANFERS INSTRUCTIONS
1.Preheat the iron to cotton setting,no steam(the temperature might be higher/lower depending on your iron)
2.Iron the clothes flat first.
3.Put the sticker on the right position.Repeat iron back and forth for 30-50 seconds.(You can increase time) Iron more corners.The back is ironed again to sure firmly.
4.Waiting for the temperature to get cold.
5.Starting tear the PVC SHEET from the corners.
Note: It can be heated repeatedly in places that are not easy to peel.(need to cover the PVC sheet on sticker and iron repeatedly) The stay time can slightly longer.
1.Temperature: 160℃
2.Press time:20s
3.After the front is ironed, the back is ironed again to sure firmly.
1.After ironing, try to wash after 48 hours.
2.Reverse wash. Avoid excessive friction, strong detergents, chemicals, etc.
UV DTF STICKERS INSTRUCTIONS
- ①First, wrap the sticker around the glass, watching for overlap at the intersections. If the transparent tape overlaps, please cut the two ends to a suitable position so that they do not overlap, and be careful not to cut the pattern. (If you don't cut it, the two sides of the tape will stick together when pasting, which will make it difficult to tear the transparent film).
- ②Peel design transfer from backing. We recommend the graphic side down and the white side up to start tearing the clear film. Please note that if the edge of the pattern appears and cannot be peeled off from the transparent film, please wipe it with your fingers and press it several times so that the pattern stays on the adhesive paper.
- ③Place the transfer on the cup ensuring design is straight and positioned correctly.(The adhesive is very strong. Once the transfer touches the glass its impossible to take off)
- ④Use a hard plastic card similar to a bank card.Press the transfer down, working from the centre outwards, pushing out any bubbles.
- ⑤Swipe along the edge to make it easier for the glue to stay on the clear film.
- ⑥Peel clear film off slowly and you're done!In the process of tearing the transparent film, if you encounter small patterns or corners still sticking to the film, please press repeatedly with your fingers or a hard card board to make the pattern stick to the glass. If the pattern cannot be attached to the glass, please tear it off from other sides and repeat the above steps.
Attention
- ①IMPORTANT:Hand wash only. We do not advise to put in dishwasher or microwave.We are not responsible for application mishaps.
- ②Not all brands of 16 oz/20 oz/24 oz. glass cups have the exact same measurements. They can differ by a couple of millimetres.
- ③Our wraps have been measured to fit Libbey glass cans.If your cup is too large and there is a gap in the middle, it is a normal phenomenon.
- ④This product is not suitable for sticking to irregular, uneven surfaces. If a customer tries unsuccessfully on their own, it cannot be blamed on a product issue.